Didn’t change the y bearings
Type: Posts; User: knotjustsawdust; Keyword(s):
Didn’t change the y bearings
No noises when it’s moving. I just replaced the y motor also.
Changed the bearings , tested y and z and both move smoothly now. Just did a small 12 inch sign and it was going good until I got a clean y rail message.. I cleaned the rails and it went for another...
I will order both, thanks for the help
That would be the adjustable bearings not the fixed , correct?
Guess it’s time for me to buy a new z truck
If it is the bearings how do I go about replacing them??
Z truck is not moving up and down smoothly. Also carving is looking very rough. Any ideas?
Was just cleaning my machine afte a carve and I can’t slide the y truck. I just did the user tests for z and y and everything moves fine. The truck returns to the left (keypad side) and with the...
Looking for a pattern for the NYPD sergeant badge.
Anyone have a good pattern for a sergeant badge for the NYPD?
Thanks, I'll try raising the board. Not using any special woods, just regular pine.
I use the universal carrier base for almost all my projects, recently it's been giving me problems. I'm always getting a check board sensor errors when measuring.. but if I just put a piece of wood...
Thanks for the help
Yes , it's the business card holder
What does press enter to proceed board (back) mean???
8639686397installed the new y gearbox and I got through a 3 hour carve with no problems. I hope this fixed my problem. These pics are of the old y gearbox that I took out. Thanks again for all of...
tightening the belt and checking for missing teeth was one of the first things I tried
Yes I do hear the pops as it moves to the right side. I think I'm just going to buy the new y motor and gearbox. I'll order it today, thanks for all your help, I'll let you know if this worked.
Ther is a very slight movement
The y gearbox doesn't look worn, one bearing on the z truck was loose, maybe that will fix my problem
This has happened with any project I have tried. I sometimes use the universal sled for projects and the same thing happens. I am going to check the Y gear box tomorrow like you suggested, I hope...
i purchased the machine new about 6 months ago from carvewright. I haver about 90 hours on the machine. I have noticed that my last few carves before this happened were a little rough.
carvewright told me about the belt tension, I took the belt off, checked for missing teeth, everything is screwed down as tight as possible.
Yes they did have me try that. This problem is happening with every project, not just one particular sign.