Search:

Thanks Oscar!

Thanks for the reply Jerry. I've seen his posts also. I'll try to reach out to him.

That looks extremely close to what I need. How did you do it? A 3rd party program? Can it be done in the "basic" software or do you have to do it in another and import it?

thanks, Dave

85066I have searched the patterns in the store and forum but cant find a pattern for the neck of a dulcimer. Will the CW carve this type of design? If so, anybody know where I can find a pattern...

My part arrived at Carvewright on 2/19 and I haven't had any word yet of when it should be shipped back. I phoned, and they are backed up and said it would likely take a few weeks. I stopped by...

You may already know this, but it took me a while to figure it out. If you want to cut a project which is 5" wide, you have to allow for the 1/2" that it won't carve along the edges. If your...

An update to my plunge and board sensor problem. Worked with The infamous Bard to troubleshoot. He determined the Z Pak needed to be repaired, along with the board sensor. Packed them both up and...

I pulled out the sensor last night and took the clear window out and cleaned, and wiped the sensors. There wasn't any sawdust in the unit, but I cleaned it anyway. I have been having to use masking...

I have experienced the plunge problem twice so far, but haven't gotten a call back from CW yet to troubleshoot. I would hate to wait for a month for a new chassis if there's a way to fix it until...

I've seen posts about not enough pressure on the rollers, but I have the opposite. The clutch doesn't disengage until I have too much pressure on the board. It causes an error to check the board, I...

They both look great. My software doesn't have the Angel pattern. Would you share it?

The sled looks great and I'm pondering building one...just wondering how to do the measurements for projects without messing up alot of wood. I'm trying to get away from leaving the three inches on...

ok...I can see the need for the sled, I just don't know how to use it. Do you have to figure out the measurements of where the carving will fit on the sled and create the pattern to allow for the...

Mine is doing the same thing. I've removed and reinserted the card several times, but nothing...What does it take to fix it? What was your fix?

Well, I've read the troubleshooting posts and don't see this problem. I downloaded the new updated software, flashed the memory card, and placed a project on it. Inserted it in the machine, turned...