Start with this. The zipped file is a vector of your picture. Easier to edit. I only spent a couple of minutes on this. So fool around with it and see what you can do.
Type: Posts; User: Dastardly Den; Keyword(s):
Start with this. The zipped file is a vector of...
Start with this. The zipped file is a vector of your picture. Easier to edit. I only spent a couple of minutes on this. So fool around with it and see what you can do.
Usually I'd say between five to ten minutes...
Usually I'd say between five to ten minutes before I flip the board.
Chris have you been able to dublicate this?
Chris have you been able to dublicate this?
Is this what you mean by carving the rest of the...
Is this what you mean by carving the rest of the material. If so I just drew a rectacle and told it to carve region and set the depth as the same as the image. The carve region is the far left tool...
To cycle the machine is to turn it off then on...
To cycle the machine is to turn it off then on again after about 15 seconds. Your machine should have come with a small piece of of metal taped to it that is the flag. Mine came shipped loose. Did...
By chance have you tried to manually push in the...
By chance have you tried to manually push in the two cover switches? You will have to push them both in at the same time and that should clear the message. Might need a second set of eyes to check if...
Just copy and paste what you want into wordpad.
Just copy and paste what you want into wordpad.
It just misses on the surface find.
It just misses on the surface find.
Finding bit on two sided projects
I've had the CW on a almost all two sided projects not find the bit after the board is flipped. It does the normal finding the bit steps but never does touch the board. Its usually around 3/16" off...
There should be a brass ring on the flex shaft...
There should be a brass ring on the flex shaft cable at the head end. If not call Carve Wright and they will send you one. It keeps the shaft from traveling into the head and coming out of the motor.
The project is roughly 13 X 9 and the board...
The project is roughly 13 X 9 and the board setting in the project was 14 10. I wasnt asked to autojig. I Tried the same pieces with another project that I had set the board settings to the size of...
incorrect measurement
I have tried to different pieces of poplar 11 X 18 for a project. With both pieces the machine asks me if I want to scale to length. It is measuring both boards at 10.93 and 10.98 inches instead of...
Fatal Error #2
Machine stopped in the middle of an hour and a half project with Fatal Error #2. What's it mean.
I had this error last night. I hit stop so I...
I had this error last night. I hit stop so I could lift the lid and clean out some debis. But instead of the head lifting straight up and the motor coming to a stop. The motor shut off and the head...