Search:

As you are looking inside the CW through the lid, on the right side (furthest from the keypad) just above that gear is a screw. Just push the plate to add tension and tighten the screw. That is if...

As you are looking inside the CW through the lid, on the right side (furthest from the keypad) just above that gear is a screw. Just push the plate to add tension and tighten the screw. That is if...

Is your board uniform in thickness? A wedge shaped board will break the X Drive Gear or jam.

A: the board has been milled through my planer to a uniform size of .969 of an inch as measured at each...

Jeff, I reinstalled the door sensor cable, but it took several hours of doing everything but standing on my head. Now my X-Stall error 238 is back. I have cleaned the machine thoroughly and...

I assume that I will have to remove the top cover again in order to see the circuit board below the Y axis motor.. Corrrect?

My problem started with an X-stall that could have possibly been caused by a piece of rubber that dropped from a deteriorating flexshaff - although never proven. During my search (by feeling track...

To:
Digitalwoodshop
Senior Member

If you have the machine square the joint then carve or cut, what keeps the board from flipping up jamming the bit in the wood.... Is the board being held...

Also, note that this machine has very few hours. I have been quite ill this past year and only recently began woodcarving again. I live in Alabama and the summer has been reasonably hot. My workshop...

I assume the best way to examine the belt is to pull the cover aince I cannot see the whell since this is the Sear's model. Never have done this before - any suggestions?

I have felt the track but...

I am encountering a Y-Stall error 238 while attempting to carve a project. The pertiment details of my CarveWright Machine are:

Firmware Revision: 1.130
Sec. Revision: 7
Firmware Build:...

Chuck,

My experiece was that a Carvewright representative called me the next day and directed me in a process to activate the Centerline text. Nothing comes through the mail - the Centerline text...

The board sensor appears to be okay according to the configuration test results.

However, this is what is happening now. After checking the sensor, I retried my project(s). In every case when it...

Thanks for all the replies.

I will verify that the Board edge sensor is working tomorrow and then I will make my decision about returning it for refund or replacement.

I think I have about...

As I a new owner of a CarveWright (CompuCarve ?) machine from Sears, I have experienced a phenomenal number of problems with the machines. I also realize that I may not be as skilled in their repair...

CPU stands for Central Processing Unit. Technically it's not the computer tower per se; but, rather the components that process the computer instructions within the computer tower. In the case of...

Question - is your computer an older model with V.1.0 USB ports? I would suggest installing a version 2.0 complient card. You will get speed plus power.

The software worked on my system without...