Thanks for the info everyone..
Type: Posts; User: mikedhill1; Keyword(s):
Thanks for the info everyone..
While putting a new board into my machine, the Crank Torque Plate broke in half. I assume that I can order a new one on Monday. I was just wondering if this is happening to anyone else? Also is there...
Thanks for the offer, but I can wait until monday, and I will order a few extra to keep on hand. I am just glad I was able to get it figured out so quickly. Once again you guys have helped me out...
Just disconnected the FFC cable from the truck head and found a break in the wire right at the black plastic covering.
Ok I'm pretty sure it is the FFC cable. So how do I go about ordering a replacement cable?
The first time it happened was during carving, now it happens while measuring the board.
I was carving a pattern when this error showed up. I turned the machine off, and back on, but the error was still there. I manually moved the truck back towards the control side of the machine....
Thanks for the info guys
Is there anyway to add new fonts to the software?
Well I got this figured out finally. It was the micro switch that cuts the motor. The cover would close and activate the switch, ( but just barely) but as soon as the truck started moving, the motion...
Thanks brdad, I think I'm going to wait until tomorrow and call CW, see if they want me to send it in for repair or if they can walk me through a few things. Thanks everyone for your help, I really...
Ok, I put the motor back in, checked the C1 capacitor, looked fine, checked the power supply, also looked fine, put everything back together, tried the pattern again, I put the bit in, the motor did...
Ok, I checked both of the lid switches, they are fine, I removed the motor, and opened it up. I bought the machine brand new, it only has 25 hours on it. The motor has lots of wood dust inside, but...
Thanks for the replies , I'm heading out to the shop to check these now, I'll let o\you in a bit..
I received my machine on Wed of last week, and it has worked well since I got it until last night. While cutting a pattern last night, the cut motor rpms started to fluctuate. Before I was able to...
I'd like to, but it's goning to have to wait until I can afford the trip
Got my new Carvewrught last week, and have been learning on it at every opportunity. Have had nothing but fun so far..
Hi, I just got my Carvewright last Wednesday, had a problem with a microswitch, which the staff walked me through, got me up and running, and I have been learning by trial and error ever since. Let...