Search:

Type: Posts; User: firedawgbw; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    5,763

    Help with turning picture into a pattern

    Can anyone help me with making a picture into a pattern?83598
  2. Replies
    25
    Views
    8,717

    I'm still trying to fix my machine. Guess I'll...

    I'm still trying to fix my machine. Guess I'll start from scratch too. Thinking about unloading it all together.
  3. Replies
    25
    Views
    8,717

    If the FFC ribbon cable is damaged at all, will...

    If the FFC ribbon cable is damaged at all, will that keep the cut motor from turning?
  4. Replies
    25
    Views
    8,717

    I tried the wires both ways from the switch and...

    I tried the wires both ways from the switch and the motor still does not turn.
  5. Replies
    25
    Views
    8,717

    I'll check the flex shaft but shouldn't the motor...

    I'll check the flex shaft but shouldn't the motor still make some type of noise or try to turn?
  6. Replies
    15
    Views
    4,777

    Is the 'elevated tech support' worth the extra...

    Is the 'elevated tech support' worth the extra money?
  7. Replies
    25
    Views
    8,717

    Ok, I checked the brushes on the old motor out of...

    Ok, I checked the brushes on the old motor out of curiosity. They looked fine. The new cut sensor checked out fine on the sensor check menu when I turned the chuck by hand. I looked at all the boards...
  8. Replies
    25
    Views
    8,717

    I tugged on the C1 and it was secure. Anyone in...

    I tugged on the C1 and it was secure. Anyone in the state of Georgia that can help out? No luck with support.
  9. Replies
    25
    Views
    8,717

    I checked the circuit board underneath and...

    I checked the circuit board underneath and everything looks fine.
  10. Replies
    25
    Views
    8,717

    I've replaced the cover switch opposite the...

    I've replaced the cover switch opposite the keyboard already. I'm clueless. I can't get in touch with Carvewright due to the power outage. Is there anywhere to get these machines repaired?
  11. Replies
    25
    Views
    8,717

    version 1.164

    version 1.164
  12. Replies
    25
    Views
    8,717

    Cut Motor problems

    I was getting a check cut motor error message on the machine. After talking to support, I ordered a new cut motor and sensor. After replacing them both, I am getting the same message and the bit is...
Results 1 to 12 of 12