To the Forum members,
I apologise for being so negative as it would probably upset me to see others acting in this manner. I am having a few personal difficulties
at this time but that is not a...
Type: Posts; User: Shawn Gillies; Keyword(s):
To the Forum members,
I apologise for being so negative as it would probably upset me to see others acting in this manner. I am having a few personal difficulties
at this time but that is not a...
Using Firefox the space where the phone number should be is a purple line. I dragged the mouse pointer over the line and the phone number shows...move pointer away and number vanishes. Who knows,
edited
Jeff. What are you? The house detective? You don't know nothing about my situation so just clam up! You Mods are getting just a wee bit to cocky. Look when i signed up. I have MANY e-mails regarding...
That's strange, try clearing cookies (i clear mine every shutdown).
Just checked the page...no number, only address.
EDITED
edited
When your replacement or repaired machine was sent back to you did you receive an e-mail or ANY conformation that your machine was being shipped back to you with or without a tracking number?
I...
menewfy, i am curious on how you purchased your machine. Did you drive over to the USA or have it shipped?
Onto the other thought, could you rent out a post officel box and register it to that...
I'm thinking g of running 1/4" copper tube air lines running x/y and fabricating air jet nozzles on my lathe blowing air downwards in various directions (i will have to play around to find the...
I use a steam box for lumber which makes the wood malleable and then once it is cooked i lay it over a form shaped like an arch, as an example those bent wood chairs Ikea sells and then the vacuum...
Hey Maccarving, you got me thinking with that idea!
You might be able to do this.
Make both male and female dies
Place plastic in oven and heat to temperature where the plastic would become...
Regarding your question regarding the concave/convex profiles on the same piece the answer is yes. I made(well would have made but my drive belts tore apart) breadboard ends for a coffee table with...
EDITED
edited
Contact CarveWright regarding your problem. Now to get you running for now, here's what i have done (many times).
Take off the side panels and you will see a spring loaded onto a pin on the inside...
Very nice! Did you have to fasten it down onto a sled or a backing board?
SG
edited
I removed the message for now...
SG
I have had to take off the side covers more times than i can count. Spent 3 hours working on it and when i went to run the program i got a close cover message. Tracing the wires it seems the wire...
If your project is wide enough, and your belt is only shredded on the edge you might be able to use a sharp blade and trim the edge off of the belt. This may hold you over until your replacements...
edited
Very nice design. Could you post the file? Always interested in how others are doing their projects.
SG
Not sure if this will help but when that happened to me i closed the Designer Program window down and the download completed.
SG