Search:

Yes I was plugging into the Z truck. I was looking for some type of guide on the site. Also I sent my Compucarve in for repair and when they could not repair it after three attempts they replaced it...

Sorry if this is a repeat question. I haven't scanned anything in a while. I installed the CT months ago and just realized it doesn't have the connection for the scanning probe now. Where do I...

Thanks for all the comments. Only sold one basebaLL shelf this weekend. spoke with other exhibitors and sounded like they where all slow going this show. The experinced exhibitors said the good shows...

Here are some of the other shelf designs. The Top Shelf Creations sign is my business sign and the cabinets is the trade show back drop I made to show the shelves. The cabinets break apart into 4...

I have been working the last 8 months to design a production type product to fill in between the custom projects. I wanted something I could use the same basic shape but make many different designs....

Didn't get the upgrade but did just install the CarveTight last Wednesday and it is great. Everything they said it would be, very little sanding needed.

Spoke with LHR they said the serial number that came back with the machine that is not mine was from a unit that has never been registered. Sounds to me like sears is either using refurbished/used...

I am battling with them as I write this. I call them 3 times a week trying to get my machine back. They said it is my machine and will send it out when serial number is corrected, but they do not...

Last month I had requested help with a y axis stall 303 after receiving my Compucarve back from repair for a door open error and a chuck replacement. Since then I thought I had it fixed but it would...

I had to send my compucarve in for repair. Took it to my local sears store & they sent it to the service center. Did'nt cost me any shipping. Took about a month and a half to get it back, parts were...

Thanks for all the suggestions to solve this problem because while checking your solutions I noticed a small nick in the top/rear of the upper Y axis track. Sanded with some 320 grit paper and all...

Thanks, I do appreciate all the comments from everyone, success and all the best.

It was a 2/0 maple door I knocked out the panels and carved them, installed them a little lower to create some depth then inset the glass. Added a border of lyptus to widen the table.

Thanks, Yes it does have glass inserts over the carvings.

These are all Christmas presents i've made for family. The table is made from a maple door I was given. The jewelry box is made from Misquite logs I picked up in Llano at the in-laws. The truck...

Thanks, I did hear a little grinding I've never heard before, sounds like you might be on the right track. Will check it out as soon as I can and get back with you.

Checked all suggestions, Board stays under rollers, have always used loctite on all my bits. doing everything according to the instruction manual. Only change is just returned from being repaired....

Thanks I will try it again tomorrow. Should have been under both rollers but will make sure i didnt do something wrong. New to forum but using the compucarve for about 18 months. Second run after...

Posted earlier but thought I should put the error code in the title, Thanks

Error 303 Y axis stall any suggestions? Didn't see any posted