Search:

im looking for some third party pattern makers. some years ago i purchased some palm trees but lost the patterns when i got a new laptop. got any connections?

I'm looking for a hand in the shape of a peace sign or victory sign.

hello all! been a while since ive visited the forum. have and am still using my COMPUCARVE Carvewright (Sears in 2006). just for friends and projects now. still running though. good luck and keep...

Thanks all!!! O ring got pushed over. Up and running again!!

Just installed 1.153. flashed card. started project. measured width. went to measure length. measured length and the cw started to go back and forth, slowly at first then started to go a shorter and...

I recently updated to 1.150. When everything upgraded I got the you must register note on my carvwright designer screen. centerline text is gone. am i missing something?

There are some GREAT downloads on carvewrights site that can help you adjust the belt and many other things check them out.

Well my wife saw this and put it in my LIST!!

Thanks! I'm getting a new laptop for X-Mas (Santa told me so) and I want to runn all of my software on that also.

Did they charge you another $100.00??

That is absolutley amazing! Thanks for the pics. Just to cool!

did you try it twice or just once?

Remember that the Moly lube is DRY lube. Is ER a drying lub?

Also, go to Troubleshooting. The top thread has lots of GREAT downloads. I made a complete printout of all of them and keep them in the shop.

I am running 1.121

The o-ring looks fine. I will take another look at the encoder and maybe take a picture to show you.

Well, I calibrated my cw. The stepping was reduced. It still will not measure my 20.5" board. It keeps reading around 20.113". Even with masking tape on the bottom. I did another cut path with...

I will try these things in the morning. Thanks for all of the help. We have been in the middle of MAJOR reconstruction and have not been able to get back into this forum for some time. It sure is...

Thanks guys,
I will be able to try some other things before I call LHR. I did put new sandpaper on not long ago and my cw is extremely clean since I tore it completely apart to clean it. I did have...

I have done that but still am not getting the correct measurement. I put in a clean 20 1/2" board and it reads 20 1/8". Also on cut path I am getting a Step cut on each pass. It is like it is...

any big box home improvement center would handle them.

I always keep a slightly bent hacksaw blade handy and push the metal bit finder under the bit. After that I don't usually have any problems.

It depends on wether there is a flat spot on both sides of the bit. Some only have one. That will make it stick out further.

I remember seeing a picture of a carved electric guitar. Can anyone direct me to it? I have tried search and just come up with real guitar paterns. All that I want is a carving of an electric...

Hi guys! It has been a while since I have been on this forum. I kind of miss this. Even so, it may be good because I have not had a lot of problems. I called LHR on Tuesday and had some issues solved...