I bought a second machine because my first was down so often (a long story) and I was simply unable to get the cover to engage the cut-motor cutoff switch correctly so, I bypassed it. This thread has...
Type: Posts; User: msgtray; Keyword(s):
I bought a second machine because my first was down so often (a long story) and I was simply unable to get the cover to engage the cut-motor cutoff switch correctly so, I bypassed it. This thread has...
Well... it finally failed. Machine simply went dead shortly into a project and would not reboot or power up. Power supply and controller are both shipped off to support for testing.
I spoke too soon. It is still aborting occasionally. I guess I'm going to have to live with a "machine with a personality" (at least until whatever is wrong causes a hard failure). I am really not...
Thank you to everyone for suggestions and comments. I re-formatted the card AND purchased the largest UPS I could find (1500VA - 900W) to condition the power. Between the two, I've made it through...
OK, what are the green "thumbs-up" on the right side of each post? (Yes, I am as green as grass). I thought it might be a gratitude type system but when i click one it turns into a red thumbs-down...
Thank you for all the feedback. After I made my initial post the machine did something different. It got to about 80% on a carve and stalled with the cut motor running and the truck simply hovering...
I am a fairly new user, so I don't know what is "normal" for the CW. My machine has recently started to simply abort back to the "1) Project menu" mid-project. The cut motor stops and the z-truck...
My name is Ray and I purchased a CW (new) in December and simply jumped in the deep end of the pool. I have to say, if I wasn't extremely happy with this machine when it works, I might be depressed...