Search:

Type: Posts; User: geno147; Keyword(s):

Search: Search took 0.00 seconds.

  1. Thread: Error E34-0204

    by geno147
    Replies
    8
    Views
    6,476

    No longer a good link

    No longer a good link
  2. Thread: Z-Truck errors

    by geno147
    Replies
    2
    Views
    1,250

    More Parts?

    I started buying 2 of everything just in case, is there somewhere we can buy parts in bulk? HA

    Gene
  3. Thread: Z-Truck errors

    by geno147
    Replies
    2
    Views
    1,250

    Z-Truck errors

    Does anyone have a "what to check" tree for z-truck errors? This is an on going problem with my machine. I had the same problem last year and finally sent the machine back to LHR for repair. It...
  4. Replies
    16
    Views
    4,118

    Thnx

    It would be nice if we had R&I instructions for all these things. I got that tightened up and adjusted the right side which seems to have taken care of the head looseness. Project seems to be...
  5. Replies
    16
    Views
    4,118

    Ah Ha!

    Thanks for all the suggestions, I think I have discovered the problem. Facing the z-truck, the lower left guide is loose. The screw will not tighten or come out, just turns. When turning the guide...
  6. Replies
    16
    Views
    4,118

    My cut-through is intentional, the problem is the...

    My cut-through is intentional, the problem is the curved lines on the face of the arrowhead. I will look at this though once I get back in town and see if I can come up with any suggestions.
    ...
  7. Replies
    16
    Views
    4,118

    Photos of problem

    Here's a couple of photos, thanks to twoatlow8.

    Head checks out level. I put in a new carving bit and they are coming out cleaner again but still this problem shows up.

    Later
  8. Replies
    16
    Views
    4,118

    Thanks for the reply, I will go out and check...

    Thanks for the reply, I will go out and check that out. Never been accused of being very level headed. I'll let you know if that does the trick.

    Thanks
    Geno
  9. Replies
    16
    Views
    4,118

    Oops

    Sorry, the photo didn't upload, let me try again. Labeled ( 3 ) Well, too large to upload & I'm not bright enough to save it smaller. can email photos.
  10. Replies
    16
    Views
    4,118

    Carving depth problems

    Hey all,
    It seems about every other time I fire up the carver I have a different problem, I seem to be a problem magnet. The best way to describe the problem is photos, see attached. The problem...
  11. Replies
    2
    Views
    1,348

    Thanks for the reply, that's what I decided too,...

    Thanks for the reply, that's what I decided too, I haven't tried it again since I discovered the case crack and haven't had time to call yet. From what I have been reading here it makes me think...
  12. Replies
    2
    Views
    1,348

    Need lots of help!

    I am a longtime woodcarver but new to power carving so, after reading the owner's manuals, setting up the machine (which seemed way too easy), preparing a project and attempting to carve it, I found...
Results 1 to 12 of 12