Ordered, thanks guys
Type: Posts; User: badger2424; Keyword(s):
Ordered, thanks guys
Yes you are right I didn't notice that and not much familiar with bearings but a regular 688rs should do the trick thanks
Thanks for your help, I will keep looking.
Measured with caliper.mm is a digital reading, inches was manual caliper, and I got the same problem when I looked number up.
8688386882 this is the stationary tube in which the rubber conveyor belt rotates on
Finally found a number with jeweler visor 688RS
Or 19.5mmx6.92mm with 8mm diameter hole
Bearing has no numbers but it's 3/4" tall, 1/4" wide with 5/16 diameter hole
Rubber Belt wasn’t tracking straight took it off an found I’ve got both bearings needed to be replaced on the in feed side of the stationary belt conveyor tube. LHR doesn’t sell these an was...
Thanks for all the response and you guys were right, dull bit. Sent the dull ones to Nelson, seems like a great fellow by the way, for $8 a piece. Can't beat that! Dian I do keep a bottle trend tool...
Just talked to this guy, Nelcyn, only charges $8 a bit and has other Carvewright customers. Sending 2 of mine and will let you know how it goes. http://www.nelcyn.com
Found a bit I didn't know I had, going to give that a try an will get back to you. Thanks
Nope don't have one at the moment, guess I need a new one any how. Good excuse to get another. Will send the other 2 to your guy above to see how good he is. Thanks for the info.
No not the first, the pictures are from 2 different carves. Started 3 carves ago. Everything is tight bearing wise and don't know what to do to the encoder except check for dust, none there. Got me...
Can the 1/16 ball nose bit be sharpened?
Everything is tight, checked that an the bit is fairly new with about 60 hours on it. The wood is red oak which I have carved many times with no problems. Have taken the z truck off an put new rails...
I'm having a roll-up problem where the Carver carved to the letters and then rolls the wood up at the edge of the letters Plus carving seems to be less detailed on optimal than usual. Seems to me I'm...
I use ash on a lot of sports signs, natural finish with a stained oak trim and it works great. Very little sanding clean up.
Found a guy today who said he can make the y gear shaft. Supposed to get them (ordered 5) next week and will try them to see how they work and let you guys know. It's ridiculous that I now have 3 new...
Or Red set handle is engaged. Yep, I'm stupid and done that myself.
Thanks Al.
Excellent bj, greatly appreciated!!!!!
Hey guys, anyone with the EMT star of life pattern? I can't get the snake right when I use the jpg. Thanks Tim
dltccf, welcome to our addictive world of carving!! Any problems come up, let us help, these guys know all about it.
Guido, just to let you know, when you use a back ground pattern, and merge additive, the back ground texture will also be on the pattern u merge. Gread for domes and such but mostly bad for back...