I just started a test carve, and it does not even give the Scale option and it measures the board, when you have "Conform" applied to centerline.
AskBud
Printable View
I just started a test carve, and it does not even give the Scale option and it measures the board, when you have "Conform" applied to centerline.
AskBud
Bud,
Thanks for the update. Sounds like your board size was good also..
"This will only effect you if you choose to scale your project at the machine i.e place a board of the wrong size in the unit and press to scale."
My thanks as well LG,
The 1st comment caused me a few moments of Buyers Remorse until you explained what was really involved on the CW but not in Designer.
If your board is a different size, you may resize your Design board, and then resize the entire design, and re-load to the Memory card. Highlight everything and make it a GROUP. Now highlight everything again, and drag the YELLOW point as desired. Caution: Do not use the "Center Icons", as they you center all items as directed.
AskBud
Attachment 39194
Scaling is disabled on conforms, yes. This is because although you can scale the project at the machine, you cannot scale the size of the vector bit! As a result, we cannot accurately determine how the bit will affect the board being carved.
Some of you may also notice a new scaling prompt at the machine: "IGNORE SCALING". When you're not conforming, if the board width is slightly smaller than the project width, this 3rd option may pop up. It effectively cuts off the "north" edge (next to the sliding plate) of the width of the project.