Printable View
I have had problems with my machine on the first pass of a carve. I am attaching a photo and need help with the solution.
I am running the latest version of the software. Basically on the first pass it goes too far and wont center on the board. It asks to center on board an I tell it yes, then it puts it at the top. Temp 72 degrees Suggestions welcome.
Thanks
Try reformatting the card and check the FFC cable. That may not be the problem but at least you can eliminate the possibility.
This is a classic Y Gearbox Failure. Your two 685ZZ Bearings in the Gearbox have gone bad. Could be your shaft on the Gearbox shaft has worn. Lets the big gear lean toward the center of the machine and the servo motor skips a few teeth. Then continues to cut but now in a new position.
The fix.. two 685ZZ Bearings. Or if you have the new gearbox it has a bigger unknown size bearing in the front.
If the shaft is worn thin then it will need to be replaced or the gear will still tilt.
Tim sells the replacement shafts. Or you can buy the Y Motor Gearbox from LHR for $110.00 each. I just bought 2 yesterday for a project.
If you are in need of the bearings, I have them for 75 cents each plus shipping.There has been a suggestion of removing the inner seals and adding extra grease, but I have not tried that as of yet. The bearing I have are 685 2rs not the 685 zz. The bearings I have got rubber seals in them not just dust seals as the zz prefix designates.
My Machine just started doing the same thing. I did all the steps Nick suggested, couldn't find anything wrong. After putting the machine back together. I get a please close door message. Have not been able to find the problem. Will call Monday to talk to Nick.Tried new cable and micro switch, which was not the problem.
Make surethat the white wire will be oriented toward the non-keypad side of the machine for the wire harness from the cover.Quote:
Originally Posted by Ric
The close door message is telling you the right side micro switch is not closed or there is something wrong in the wiring to the motor. A cheap meter would be helpful here. You could use the ohm meter to check the switch and a voltage meter to see where the power is. One other way to check things is to jump the two wires running to the switch together and see what the machine does, remember that you have a safety jumped out and to stay away from the spindle while try it machine out just in case the motor tries to run. This most likely will not happen, but that is what the switch is for. If the message goes away then the switch is bad or the pin of the switch is not being depressed enough to make the switch close, there is a tab on the cover that pushes the pin. After testing remove the jumper from the wires and wire them in as it was originally.Quote:
Originally Posted by Ric
Problem was the Ribbon Cable not fully inserted in the "Y" motor.Quote:
Originally Posted by Ric
Was the board sensor over an uncarved area when you started the second pass? When I do 2 pass carves I don't power down or remove the board between passes. The machine remembers the measurements and just asks you all the questions so no measuring.
Clint
Close Cover message is the LEFT switch (Controller Cut-Off Switch).Quote:
Originally Posted by Mugsowner