This is the presentation from the CW DISCOVER Conference 2012.
Attachment 54421
Printable View
This is the presentation from the CW DISCOVER Conference 2012.
Attachment 54421
Outstanding and overdue ! Thanks so much to the team for putting together an official list of items to check!!!
Very Impressive... I will add "Please read THIS" to my Soapbox "Please read Tips and Tricks..." to the new guys.
Good Job !!!
AL
Thanks Connie for sharing! Good info for us to follow as we use or machine and want to keep it working correctly
This should be posted to the section of the website that contains all the other machine documents so it's easily found by users that aren't visiting the forums.
Reading through the PDF I wanted to mention that in the section where you are instructed how to re-tighten a loose Y-Belt that it should be noted it's possible to over-tighten this and cause damage to the gears of the Y motor pack... I speak this from experience !
The article mentions 4 approved lubricants for the guide posts and lead screws and none of them are the lithium grease which was recommended in the head pressure PDF... is this a change that replaces previous recommendations?
The info I got over the phone back when I made the adjustment was to slide the Z truck to the front of the machine and then towards the back end of the machine, press the upper half of the Y belt down. You should not be able to easily press it down to a point where it can touch the other half. When I loosened the screw and tightened the belt I put what was most likely excessive force on the plate and ended up bending the gear...