Evidently, the 2d Vector Tools cannot be protected in DEMO mode. So, no, this Suite will not be available....only the Pattern Modeling Suite.
Printable View
Hi Metallus,
He sent his image to me and I tried it at my end. It imported for me, no problem. It is a very small file size already...only about 28kb (it's a jpg). He already tried turning off, on, auto, boosting his cache size...doesn't want to work on his system. I advised he check for video driver updates, but I suspect his video card may be an older, less capable one. I mentioned he may want to call Tech Support and see if they have any other suggestions...he may just need to upgrade his card with a new one. Perhaps the copy/paste might work for him...I didn't think of that.
hey brdad, I asked the same question and Mike said that you will need to stick with Centerline for the type of carve you get when the Vbit follows the center of a closed vector. So, tracing line art to keep it as line art will still require using the Centerline plug-in.
Is there any written to videio on the 2D pachage yet.
Thanks Michael & Metallus for your suggestions. It finally came down to installing a new video card. It turns out my onboard video capability was the problem.
Thanks again - Doug
in the edit menu in preferance make sure your hardware accereleration is on
:-D
I have been playing with the trace comand. When I try to make a pattern it say one or more patterns belong to another owner. I just imported a drawing from free ware on the internet. I don't understan why. Any suggestions.
Seems like it may be a bug. I had the same problem with one of my MPC's .