Err-e03-0400

Hi,

I've been a long time user but not for the past few years.

I just completed a project about 4 weeks ago and it went well except it chewed up the sand paper belts at the end.

So I ordered some new rubber belts and installed them to Carve wrights directions.
When I went to start the machine up using a very good board for measuring the length and with, I get the ERR-0400, Edge detection failed.

Can any help?

Thanks

Gary

The board sensor is faulting out when trying to find the end or edges of the board.

http://support.carvewright.com/edge-...ilure-message/