My carving piece is painted dark and I’m getting the “check sensor” message. I read somewhere to put a strip of masking tape on the piece- exactly where do you put the tape? And how much? Thanks
Printable View
My carving piece is painted dark and I’m getting the “check sensor” message. I read somewhere to put a strip of masking tape on the piece- exactly where do you put the tape? And how much? Thanks
Put the tape where the board sensor will measure your board. Board sensor is located under the truck (below the bit collect).
Put the tape in a T shape. One across where the sensor measures width then again where the sensor looks for the the edge of board.