I think that the bit optimization tool just changes the step-over for the selected carving bit. Not applicable in all cases but in most.
Printable View
I think that the bit optimization tool just changes the step-over for the selected carving bit. Not applicable in all cases but in most.
See page 8, draft and page 12 bit optimization.. http://support.carvewright.com/wp-co..._Chapter_2.pdf
Thanks, Floyd, Michael, Dick and Steve for the input. I have only done a couple pierced carves and never deep ones, so wasn't able to give Peter the answer he needed. I sure love this forum for quick help a person can receive.