The new Y tension pully has no teeth, yet the old one did, is the going to cause a problem?
will have to change the Y belt too.
Printable View
The new Y tension pully has no teeth, yet the old one did, is the going to cause a problem?
will have to change the Y belt too.
Have you called LHR to ask?
I'm told that is the new design. It is to prevent sawdust from building up.
Sounds good to me, as long it does not allow slippage.
Change out Y tension assb. Very easy, I did Y test and when the truck got to the home Position to start the Y test, it just sat there with the Y belt running for a few sec. then gave me a error E12 0353.
any ideas.
Was the belt moving?
Yes , I installed a new y belt too.
You might need to put more tension on the belt then. Do yo still have the old one or have an old Z truck? The one on the Z truck is the same.
Check the belt clamp on the back of the y truck?
Yes , Y belt clamp Is tight, I even checked the Y motor and gear box to see if there was play among the gears, nothing.
never seen this one before. The truck move easily along rails in the y direction by hand.