Originally Posted by
CaptainKirk
I got a replacement machine for one that was not working well, nad it seems this one has an issue as well.
This problem happens both when measuring a board before attempting to carve and when trying to do a joint / square operation.
The machine finds the lfet edge ok, but moves the piece clear off the right end, never finding the right edge. I get errors: "check tracking roller" and/or "check front roller stuck".
I can see how I would get both of these errors, because at this point, the board is not in contact with either the tracking roller or the front roller.
I clean the sensor every time and clear the dust out after every project.
Is there something I can do to get rid of this issue?
thanks in advance....
Kirk