Printable View
Hi folks,
I make the 'Carving In the Dark' backlit LCD kit and also have bits for the CarveWright machines and other accessories. You can find the CarveWright section at:
http://www.soigeneris.com/CarveWrigh...ries-list.aspx
We have a special going now on carving bits.
This is one cool aftermarket LCD for the Carvewright I have one " over two years now" and dig it...Quote:
'Carving In the Dark' backlit LCD kit
I love it too ... I think I'm going to have to have another one.
Jeff, Do you have any 3/16 carving bits 1/4 shaft (WITHOUT THE PRESS ON SLEAVE) or have you or anyone tried the 1/4 ballnose in the carvewright (for carving) Its going in the rock. Also is the coating a lot better? Thanks
No 3/16" bits. The problem with using the 1/4" bit on a CW is that you can't tell Designer what bit size you are using. If you set it for a 3/16" bit using a 1/4" bit will carve out more material than your after. On wood the ZrN coating makes a new bit perform like one with a few hours on it but it will stay at that level of sharpness 2-3 times as long. Depending on the material you cutting it will make more or less of a difference.
The funny thing about the Backlit LCDs is that they are one of those things that you don't realize how much you'll like it until you try it. I sure would not want to use my machine without it now :)
I haven't been active here for a long time, but I wanted to do some carving again. So I ordered a new bit from Soigeneris.com the other day.
I have to say Jeff you have unreasonably fast service and shipping. It was faster than anyone should expect...lol
Thanks for great price and amazing service!
Welcome back Spalted.
Welcome back to carving Spalted! Yes he sells long lasting bits and they arrive on the west coast in record time!