Do you have the jumper cable for the probe to plug it into the cover?
DO I understand you have the new Z setup and don't plug into the Z anymore.
AL
Printable View
Do you have the jumper cable for the probe to plug it into the cover?
DO I understand you have the new Z setup and don't plug into the Z anymore.
AL
anymore ideas/suggestions on what may be causing this issue?
Make sure the plug on the Y termination plug is oriented correctly. White goes towards the center of the machine. Also make sure it is plugged in good.
Attachment 33657
When the screen shows "jog to ending corner" what are the final dimensions displayed?
Dan,
Rechecked the Y term cable -- its oriented and seated correctly
Metallus,
the final dimensions are 0.00" long x 6.79"
Andrea,
Where you able to locate the probe sensor in the options menu on the machine and if you did where you able to check to probe state?
Checking The Machine’s Onboard Sensors
The status of each of the machine’s onboard sensors can be accessed
from the LCD screen and keypad for the purpose of troubleshooting. To
access the Sensor Check menu simply select the “0” (Options) key at the
CarveWright Main Menu
or use the up/down arrows to locate the
Configurations Menu
and then press ENTER. Next, select the “7”
(Measure) key or use the up/down arrows to locate the Sensor Check
menu and then press
ENTER. Navigate through the different sensors and
associated status values using the up/down arrows.
Probe Statechange from Closed to Open.
State – Open/Closed
With no probe installed, the Probe State will be displayed as Open. The
operation of the probe can be checked while installed in the quick changer
and plugged into the connector. Once installed the LCD will read Closed.
To check the operation of the probe simply reach in and deflect the probe
tip to the side. If the probe is operating correctly the displayed state will
Attachment 33668 if so then something is not getting the length.