if i cut .625 is it going to try to cut this in one path :o i had depth set for .125 it is cutting .25
Printable View
if i cut .625 is it going to try to cut this in one path :o i had depth set for .125 it is cutting .25
Thanks!
Some guys are removing 1.130 and then installing 1.126.
after rolling back, look in your firmware directory.. save the 1.126 firmware but with a new name.
re install 1.130 and you can load the two versions of the firmware on to your memory card when needed.
LG
problem solved i had to get a new module and now it does not ask to jog to position or cut so deep in one pass
RIGHT ON .. And then some!
Alright guys, a few of these posts are going a bit too far and have been removed. If you would like to offer constructive criticism, great, this is a good place to do that. If you just want to throw a temper tantrum, this is not the place.
I would say why not! From folks that have the machine!
I have many problems with mine BUT like a wife I had... I love it!