Originally Posted by
want2b
No, did not do anything or even touch any part of the machine except hit the stop button. Checked all my other electronices in the house & shop to see if anything else indicated a power hit but nothing showed. The carver display was the same as when I left it.
Have hit the stop before and left it, can't swear it was that long but I know it was several hours while I went somewhere. Obviously the Fatal Error ( 3)! is a new one here on the forum. My only option is to shut down and begin again which I am going to proceed with, just hoped somebody had seen it and had a clue as to the cause just on case there was something I needed to do to stop a 2nd failure.
I figure if Al doesn't recognise it then I'm in the Twilight zone.
Thanks, Rick H.
ps. my shop is warm, only falls below 60 in the dead of winter during the night, was around 70 when I started and was about 62 in the AM.