Z truck is not moving up and down smoothly. Also carving is looking very rough. Any ideas?
Printable View
Z truck is not moving up and down smoothly. Also carving is looking very rough. Any ideas?
Dirty or bad Z bearings, Z bearings loose, Z gear box bearings bad or the mounting screws for the gear box to motor loose.
If it is the bearings how do I go about replacing them??
Follow the Y or Z truck replacement procedures.. http://support.carvewright.com/downl...pair-documents
Grab the end of a bit in that is installed. Tug in and out to feel for any play. if any, determine if it is the Y or Z rollers the are not tight. Use your 12mm wench (from CarveWright) to adjust the appropriate rollers tighter to the tracks.
Clint
Guess it’s time for me to buy a new z truck
You probably do not need a new truck, just the bearings.
That would be the adjustable bearings not the fixed , correct?
I will order both, thanks for the help