Another Masterpiece.....
Good Job,
AL
Printable View
Another Masterpiece.....
Good Job,
AL
Thanks for posting the video, LG. That was FUN to watch!
Are you using the CC to carve out the areas for the electronics, and the neck, in the body blank?
I want to dabble in this a bit, but everyone tells me I need to start with a 14" wide body blank.
Are you carving those cavities in each half, and then gluing them together?
I haven't yet been able to get back to using my CW, but I wanted to ask - are you using 'conforming vectors' to carve out the area? (Am I getting the terminology right?) If so (and I might have asked, and received an answer on this already - I just can't find it), do you have it carve a relief with the pattern bit until it gets thick enough to use something like a 1/2" bit, and then have it do the remainder of the cutting? I would assume this is possible, if you configure the lines correctly?
my jaw drops every time I open one of your posts... stunningly technical, well exectued, and beautiful work.
Lawrence
As usual, unbelievable job!!. Curious as to what wood you used?
Beautiful workmanship again Brandon!.... Hey, I drove right past your exit in California last week. If i had time i was going to look you up!
Hope you are doing well, and the Rock Chucks are still serving you well!
Ron
Very nice job Brandon, you just make me want to wrap my fingers around that neck and give it a try........and I'm sure it sounds as good as it looks. Thanks
CarverJerry
You do some great work. Did you get the price compared to that of the Les Paul?
Quilted Maple pick guard,, Nice touch !!!