Hi I have been asked by a local non profit to make this labyrinth. It is based on overlapping hearts. Any ideas on how to trace the outline and then use a 1/2" ballpoint bit to route? The sample one was done by hand.Attachment 88546
Printable View
Hi I have been asked by a local non profit to make this labyrinth. It is based on overlapping hearts. Any ideas on how to trace the outline and then use a 1/2" ballpoint bit to route? The sample one was done by hand.Attachment 88546
I did something like that once by using the spline tool and tracing down the center of each grooved area and then assigning the bit.
Import the image in and trace it just like Dale mentioned.
Just in case you have problems with the pattern, here is a raster version.