I was trying to use the Rotary Jig and keep getting "Calibration error" it shows old : 914 New : 1048
Any I else had this problem.
Printable View
I was trying to use the Rotary Jig and keep getting "Calibration error" it shows old : 914 New : 1048
Any I else had this problem.
I take it you are getting this on the calibration steps on a dowel?
Yes. When it turns the board around 3 times.
Your number do look like they is a big difference for the old and new. How many times did you try it and did you check your head pressure?
The jig calibration is very finicky. Make sure the jig is tight against the squaring plate and clamped down as tight as possible under the head. Remove and reclamp until the calibration falls within range.
I tried it 3 times. Its late and I have checked head pressure, I will tomorrow. When it turn the board around it stops about 1/2 turn short.
Thanks. I knew when it went right in no problem some thing would happen