Question, what is the smallest diameter you can carve down to with the Rotary Jig?
Thanks
Jim
Printable View
Question, what is the smallest diameter you can carve down to with the Rotary Jig?
Thanks
Jim
I have done walking canes that were 1 inch across
I just test carved a piece .750" deep. I don't recomend doing it, but I wanted to know how it would perform. The wood was flexing a lot as the bit made the cuts on the last 1/4" of the circumference.
I think if one had a short dowel, and used "Ask Buds" third rail, it would be fine. But then again, I'm not recomending it.
(it's not recomended that you drive a car over the speed limit, but folks do it all the time) just saying.......