Sleds

Looking for some guidance *again*. I will be carving (two sided) the front of a wine box which is .250" thick and my sled is .5". All but my lettering is set to .065", so I should be ok there, I think. My question is, what do I set designer at and when the CW asks for thickness, what do I input? Thank you in advance.

Input the size of the material on your sled. Do not include the size of your sled. It will give you a warning that the material is too thin, but you can hit continue, since you know you will have a board under it to go to the needed .5".

Thank you very much.