Not sure why I am getting this message I have more than 7in to keep under rollers, plus I can not add tabs, does using the Pierced option automatically put in tabs?
Attachment 88544Attachment 88545
Not sure why I am getting this message I have more than 7in to keep under rollers, plus I can not add tabs, does using the Pierced option automatically put in tabs?
Attachment 88544Attachment 88545
The cut path at the top of the board is to close to the edge. The path would cut down into the brass roller and it is telling you it will not cut that. To have tabs automatically always use the cut path tool. Pierced only pushes the pattern to the bottom of the board and you need to draw in manual lines for tabs and then use the add tabs tool.
Thanks will have to use a 6in broad, I do use the Cut Path tool and get the following screen then hit accept but I can not see any tabs when viewing.
Attachment 88547
You cannot see the tabs, when using the cut path tool. They are there as shown in your settings.Quote:
Originally Posted by adstaggs
Thanks that solved my issues was able to screw on another 3/4 x 3/4 board and make my cuts with an issue.