Marble Board

I did this project to learn“snap to grid” (marble holes) & “mirror all” (stars). I used the basic Project Designer using the supplied bits & 1/2”Classical. The first one was round and the holes were “1/2circles” then “carve region.” To better show the capabilities of the CW, this one was changed from round to a six sided, also I used 3d “puffing” instead of basic “carve.”

Cut into 7” walnut it took the CW a hour & 45 mins at the best setting. I just carved this on 3 June after deciding to enter your contest. Should I enter this“as is” to show how well the machine carves? Or sand with the mop and apply a finish, to show how good I am at finishing?

Gary Bagby in Austin, Texas

"Projects should show off the machine and software’s capabilities, as well as your own creativity and craftsmanship."

Nice Project, First Post, Joined in 2008.... Don't be a Stranger.... I like the way you think..

AL

Not only should you show off your finishing skills, include some nice marbles.

And we will have something to do, if the booth traffic is ever slow!!