I trying to make a cane for disabled Vet. I haven't used the Rotary for a couple of years and have forgot how. I have been putting board measurements of 10" Length, 4 " wide and .5 removal. but when I run it the bit stays above the wood.
Any Ideas
Printable View
I trying to make a cane for disabled Vet. I haven't used the Rotary for a couple of years and have forgot how. I have been putting board measurements of 10" Length, 4 " wide and .5 removal. but when I run it the bit stays above the wood.
Any Ideas
Could you post the mpc? What is the actual size of the work piece?
Here is the MPC. The board is Length 13" Diameter 4" and part off 1.5Quote:
Originally Posted by bergerud
I do not see anything wrong with the project. Minimum dowel size is 2.748" so you could use a smaller dowel.
Did you let it carve for awhile? Your pattern overlaps the "No carve" zones and so I think it was slowly ramping in. If you just let it go, it may just do it.
I thought that and I let it run for 10 or 15 trips. THANKS FOR HELP
Change the depths of all objects except for "Rotary" to .25". The rectangle also. Change the depth of "Rotary" to .75. If you want the actual final diameter to be smaller, change it in the board setup. Allow some time for the ramp-in at the beginning and end.