How small of an item can be scanned ?
Hello Everyone
I am new here and just signed up last saturday and I do hope that
I am posting this question in the right area.
I do not own a CarveWright just yet but I am intrigued by all of the
possibilites of this machine and figured I could start learning about
the CraveWright well before I buy one. I already understand that the 3D probe
is as sharp as a dart and would scratch the finish of the pin I have.
I can make a resin copy that holds the same detail of the original so that could be scanned
So I wanted to ask :confused: :)
How small of an item can be scanned wit the 3D probe
and then after scanning can the item be enlarged.
there is some text in relief on the pin, this text would be changed
The pin is 1 7/8 inch tall by 1 3/8 wide
and about as thick as a half dollar at its thickest point.
there are a lot of high and low details and the thickness does vary
And then I would like to enlarge this design so it
would fit nicely on an 11 X 14 inch wooden plaque.
as the final piece would be done in a cold cast bronze finish
Thank you all for your time
Feel free to ask any questions