If u guys have a tapered 1/8" carving bit, I don't know where it came from. I've been here since beginning of '08 and have never heard of one.
Sent from my iPhone using Tapatalk
Printable View
If u guys have a tapered 1/8" carving bit, I don't know where it came from. I've been here since beginning of '08 and have never heard of one.
Sent from my iPhone using Tapatalk
This is where I got mine.
http://www.precisebits.com/products/...arve250b4f.asp
Here is where I got mine - http://www.soigeneris.com/PreciseBit...s-details.aspx
I have used it to carve preminum pine and it has done an excellent job.
Then I guess it's just a matter of...since we don't sell it, the machine (or firmware to be more accurate) is not set up for it.
I'll ask if they have tested it and why not using it.
Sent from my iPhone using Tapatalk
Sure would be a plus for the machine.
Review post #9.
AskBud
http://forum.carvewright.com/showthr...654#post177654
I been using the 3/16" ball and 3/16" mill bit to carve tops the results in the raster speed department is worth the setup.