Printable View
I have carved this pattern so many times but the last time I tried it the pattern came out smaller. I have always used a 24 inch long board with no problems. This time it came out smaller, I did select no to stay under roller as I normally do , but now I dont know what to do. When I originally loaded the pattern and said stay under the roller is said to use a 24 in long board.
You probably had a display message about scaling. It asked if you wanted to scale the project or load a new board. If you said yes to scaling it reduced the project size. Scaling is caused by the machine seeing the actual board smaller, either width or length. I am attaching a tips and tricks newsletter that covers scaling.
Note to Connie and Joe. Some how, some way, when the web site was changed/updated some of the tips and tricks newsletter did not get included. Missing several matter of fact.
Thank you , I did try and measure a board the was 20 3/4 inches long , but machine said it was over 21 1/2 inches long. any ideas?
I would check the head pressure.