Had an error when I flipped my board

Hi All,

I was in the middle of a carve, the back side completed, I was flipping the project board went to lower had error message front roller error, so i had to figure out what to do, finally got the error cleared, went to put project board to where I left off, however it is making me start all over? Isn't there a way I can get back to the side that I need to carve? I am really trying to learn this, getting a little better bur still need help. Thanks you in advance for any help you can send my way.

Thank you
Loriblackdog

As instructed over the phone, remove the back of the project from your .mpc file and re-upload the front only with a new name for the project.

Thank you so much, and I have made note of this so it won't happen again.:p

If you have a 2 sided carve it will always cut the back side first. Just something to keep in mind Lori.