Wrap texture down sides

Hello everyone,

New CW owner here! I've searched but not been able to find the answer to possibly a simple question. I am using my CW for short run concrete tile and stepping stone models for thermo-forming molds from. My question is, how do I wrap the stone texture down the sides? These will all be created with some draft down the sides for the mold to release properly so there will be no issue of the bit being able to reach but if these sides are too sharp and square without any texture, they won't be very realistic.

Thank you in advance,

Ron and the Bullies

Could attach some sort of a picture

Have you tried merge? It might change the height. That's as close as it gets.

Clip inclusive...