What is your head pressure?
What version of the firmware are you using? It should be 3.102.
Printable View
What is your head pressure?
What version of the firmware are you using? It should be 3.102.
My guess is...99% of us aren't mechanical/electrical engineers.
Head pressure was right close to 80lbs if I remember correctly (I will check it again when I have a few minutes). The firmware version is 3.102 - I haven't had the machine a year, and it has under 100hrs on it. It was purchased new from LHR/Carvewright.
Your comfort level disassembling the machine and mine are two different metrics. Perhaps I can do it just fine with the skill set I have, and perhaps I may make a mistake that voids my warranty. I prefer not to take chances at this point.
The sawdust can cake up at the ends of the two compression rollers. It requires you remove the rollers and clean out the sawdust.
Look at these documents and see if that makes you feel more comfortable.
Troubleshooting doc: http://support.carvewright.com/stuck...oller-message/
Video: http://support.carvewright.com/clean...ssion-rollors/