-
1 Attachment(s)
Double side carve
See attached MPC. I want to do this as a double side carve, with a mirror image of the pattern on the other side. I can't seem to figure out how to get it on the back side in the same spot. I will not be doing a cut through, did that just for location. And the actual stock will be 1.25 thick. Any help is appreciated!
Attachment 84769
-
3 Attachment(s)
Here is how I do something like this. I use a snap grid. 1/4" in this case. I first tweak everything to line up on the grid. Copy and paste everything to the back. Flip everything. (Constraints off!) Then I re-position all of the pieces to the grid so they match the front side. (Flip back and forth a few times counting squares.)
-
I think the problem was the vector paths. Still getting a feel for version 3, didn't know about "constraints off". Thanks for your help! I will use this a lot.