-
Carving on 1/4" material
I am going to be using the UCB to carve on some 1/4" material. I am going to use a 1/2" waste board under it so is there anything else I need to be aware of before I start the cut? It is for a template I am making for some other types of carving I am doing and want to make sure I only cut through the 1/4" and slightly into the waste board and not all the way through.
Thanks,
Chris
-
I do not see any problems with that. Tape the boards together?
-
Thanks. That's what I was planning on doing, just did not if I would run into any issues.
Thanks again,
Chris