-
I missed up
All right I missed up this morning. I took the memory card out with the machine on it was a split second before I turned it off, now when I'm doing the backside of my board it says load board and enter it moves the truck a glitch and that's it, I don't know if I missed the machine up or how to check what I might of missed up...it being Saturday no lifeline today at LHR Could someone help me with this....... I have a another machine to pull parts from if need be.... Thank you
-
Reformat your card and reupload the project. (Cross your fingers.)
-
Unplug your machine for a few minutes while you do this.
-
I reformatted the project and same thing happened and used a different memory card.. but did not unplug the machine
-
Don't just turn off the machine, unplug it too. So the capacitors have time to discharge. 20+ minutes or more. Then try it again.
-
The led on the panel woks it goes through my projects and does what it should do maybe I need to try a different project with just the front side and see what happens
-
I unplugged the machine... and as Connie said crossing my fingers
-
That's a good sign. If it does it on a basic project, look at your x-termination card, but I'm guessing you're fine.
-
I did all that was suggested to no avail so what might be the next step?
-
Take the time to explain exactly what the machine does when you try to load and carve a simple project. (Removing the card may not be the cause of the problem.)