OK, so I am a newbee and I have successfully carved 6 or 7 patterns so far. This particular pattern I am satisfied with the test carvings on pine and now I want to carve this in oak. I have a piece of oak that is 12"L X 9.25" wide and 3/4" so I made up a jig to carve it so I don't waste any wood.
I put the oak in the jig (see picture), tried putting tape to hold the oak in place, when I load the pattern and it tries to measure the board, every time it measures it comes to the right end (see arrow in picture) that end goes to the end of the roller and it is still trying to measure past that. Setup is to stay under rollers and centered on board.
Any idea what the issue is?