Printable View
I just received the 3/16 carving bit, the designer software lists a 3/16 ballnose are they the same bit?
Also, I understood that the bit would carve to a depth of 1 inch but when I list the 3/16 ballnose and try to change the depth to 1" it defaults to .808 . How do I get a 1" cut?
Carving is .8. Cutting is 1".
Sent from my iPhone using Tapatalk
Ballnose is carving bit.
Sent from my iPhone using Tapatalk
So max carve depth is .8 and no deeper?
Thats correct. At one time it used to be 1" for carving and cutting, but I don't recall witch version of the firmware/designer it changed in but they scaled back the carving depth.
So, that means I can only carve contours .8 or less in height and anything greater is not possible. Is this due to the limit of the Z axis travel?
The reason for asking is I would like to profile half of a flask shape with a max height of 1.25 inches, I was able to probe the shape fine but cannot cut the complete profile.
By the way thanks for all the help.
it is possible with the STL importer to carve the shape in multiple carves. If you have the STL importer and pattern editor (I'm assuming since you have the probe you already have the pattern editor) From the pattern Editor you export your PTN as an STL and then import it with the STL importer The STL importer can "slice" the pattern into two (or more) pieces so that you can carve deeper than the .8 max depth.
Lawrence
Go here to view the STL lessons.Quote:
Originally Posted by lawrence
http://www.carvewright.com/2010CWweb.../tutorials.php
AskBud