when i scan the probe does not raise up just drags into the wood is this soft ware related ????
Printable View
when i scan the probe does not raise up just drags into the wood is this soft ware related ????
I would try reformatting the card. Did you manually set the scanning depth or did you let it use the floor of your scanning sled?
fixed it LOL
What did you do?
I am having the same problem when I scan. How did you correct your problem. I have reformatted the card and I am able to lay everything out on the sled and set my depth but the probe just hits the side without going up.
Need help
Check the plug and wires. Also go to sensor check to make sure the switches in the probe are working. (0 - 7 - up arrow) The state should change from closed to open as you deflect the probe.