Removing bits from adapters
Removing bits from adaptersHere is some hints on removing bits from the QC bit adapters.
The following is for the 1/4 inch shank bits:
http://forum.carvewright.com/showthr...898#post132898 Post #13
THE 1/2 INCH SHAFT BITS NEED NO HEAT. They have a nut (collet) at the end of the adapter that you will turn with a wrench, so you just need a pair of pliers or vice to hold the adapter while you turn the nut/collet.
AskBud
Still can't get adapters off
I've heated them (twice) and all the small screws are out. The glue that holds the adapters on literally ran out onto the foil underneath when heated. But I cannot get the adapters off. Even on the 1/2" which is not supposed to have glue, but sure looked like glue to me. Anyone have any more ideas I can try please? Many thanks.