When I start the project I select the program and then it states stay under rollers board is long enough to stay under rollers either way then says select back-enter and that is it basically... it doesn't measure the board ...
Printable View
When I start the project I select the program and then it states stay under rollers board is long enough to stay under rollers either way then says select back-enter and that is it basically... it doesn't measure the board ...
It may be as simple as a roller switch. What does it say after you press enter? Check the roller switches. Listen for the clicks or use the sensor check.
I made a basic carve and the only thing it does is- select project - I select it- then says to load board when it is already loaded.
Going back out to check sensors.
Thank Gosh, It was the back roller, it wasn't compressed I have it up and running---- I thought I done something bad to the machine pulling the memory card out with the machine on, it was coincidence that the back roller was stuck I though that I burned something up !!! Thank you Dan....."YOU DA MAN"
Man that was intense. I swear sometimes reading these threads is like reading a good horror novel! I always pay close attention to the details "just in case"..... Glad it worked out for you.