Welcome to the forum, and we are here to help. I have never seen a question on this forum that was not answered
Printable View
Welcome to the forum, and we are here to help. I have never seen a question on this forum that was not answered
Alright a newbie! Man you sure found the right place! These fine folks will have you carvin' like a pro in no time! Welcome!
Welcome to the forum, you came to the right place.
I'd like to say welcome also even though I am a newbe also. I have had my machine for a short time also and have over 100 hours on it already. Some words of a newbe is start out simple, (you don't want to get flustered) get a dust collector, (it will save your shop vac) Keep it clean (your machine) You know about the ABC's now you need to understand the X,Yand Z's. I have made a lot of mistakes so far and wasted a lot of expensive wood but you learn by your mistakes. These guys on this forum are great. I would bet that if you have a problem and post it you will get a response within 30 minutes, They are great. This is just my two cents
Again welcome to the group, its one big happy carving family. by the way here is my last carve.
http://forum.carvewright.com/attachm...9&d=1350968008
Ken
That is a beautiful carving.
Hello, new to the Forum. Just purchased an older, but barely used Carvewright on Friday. Finally figured out how to do a pattern and can't wait to do my first carving. Gotta do some maintenance on the machine first. Wanted one of these since the Compucarve first came out! Darren, D&M Woodworks www.kansaswood.com
Welcome Darren, the forum is a great place for info and help. Enjoy your machine and if you run into any problems we are here to help you get back to carving.
Your website looks great and I can see you adding some great carvings to your products.
Welcome Darren, nice emailing you over the week end. Hope you got things figured out now. Enjoy the machine, and any questions you may have this is the right place to ask them.