Does anyone have or know where I can get a star pattern for a flag.
Super Thanks
Tom
Printable View
Does anyone have or know where I can get a star pattern for a flag.
Super Thanks
Tom
Here is a star
If you have the 3d add-on tools it is very easy to make your own. I used the "Sweep: Corner" tool here but you can also use the "Puffing: Bevel tool". It's about 8" square but if you save it as a pattern you can make it any size. Use the "Connected Lines" tool to trace over my vector lines to draw the star. Then use the sweep or puffing tool, group and save it as a pattern. You will then own the pattern and will be able to edit or change it.
Hi Gwiz (Tom),
Just uploaded my flag stars at this post...https://forum.carvewright.com/showth...ique-for-STARS
Dev
Nice job. I think they would look even better if you set the bit optimization to "Best"Quote:
Originally Posted by DevvyM
Thank you!
Thanks for the files DEV
Using them now.....
Perfect! This was just the design I was looking for. Any chance you have a Crescent Moon? 3D like this star?
Quote:
Originally Posted by jpaluck